Engineered Veneer

Engineered Unfinished Wood veneer.  Available in 10 mil backer and 3M (Peel and Stick) backer.  This engineered wood veneer is ideal when uniformity is important between multiple pieces.  Choose from beautiful exotic and domestic veneers for a fraction of the cost of regular veneer.

Additional Information

Available in 2'x4', 2'x8', 4'x8' sheets.  Comes either 10 mil paper backer or 3M peel and stick backer.  

Choose from the following species:

Ebony
Teak
Wenge
White Oak, rift
Zebrawood


 

 

 

VENEERS

We stock a variety of 10 mil paper backed, wood backed and 3M Peel and Stick backer veneer. We have a diverse selection of veneers. Most of our more common veneers stay in stock, but some of the more exotic and less common cuts may vary from time to time. We carry veneers that are flat-cut, quarter-sawn, rift-cut, burled, figured and heavy flaked.

We also stock matching edge banding for the more common veneers ranging from ¾” to 2” widths sold by the linear foot.

Additional Information

Our veneer is sold by the square foot. We offer tier discounting on our sheets of 2’x4’, 2’x8’ and 4’x8’.

If we don’t have the species or cut you are looking for, we can special order it in for you. Typical special orders will arrive in 3-5 business days.

Application process:

 

Application tips:

Both surfaces should be dry, clean and free of wax or oil.  All painted, sealed or polyeurethaned surfaces must be sanded or roughed up with a rough sandpaper prior to adhesive being applied.  Make sure temperature is above be above 65 degrees fahrenheit for at least 24 hours before and after application to ensure proper bonding and drying.   Apply contact cement to the back of the veneer and also the surface veneer is being applied to.  Allow both surfaces to dry 30 to 40 minutes before joining, depending on temperature and humidity of the room.  Contact cement should be tacky and appear glossy.  Contact cement bonds immediately upon contact, so caution should be used to align surfaces properly.  Use a dowel rod to separate surfaces for assistance during alignment process.  After surfaces are joined, pressure can be applied to surface starting in center and working out to edges.  No clamping is required.

Here are some of the species we carry:
ADLER
AFRICAN ROSEWOOD / BUBINGA
AFROMOSIA
AMERICAN WALNUT
ANIGRE
AROMATIC CEDAR
ASH
BIRCH, RED
BIRCH, WHITE
BIRDSEYE MAPLE
BLEACH TEAK
BRAZILIAN CHERRY
BRAZILIAN ROSEWOOD
BURL ASH
CHERRY
CYPRESS
DOUG FIR
ELM BURL
GRAY ELM
HICKORY
KNOTTY WHITE PINE
KOA
KOTO
LACEWOOD
MAHOGANY, AFRICAN
MAHOGANY, HONDURAS
MAKORE
MAPLE
MAPPA BURL
OAK, RED
OAK, WHITE
PECAN
PINE
POPLAR / MT. TULIP
PRIMA VERA
PURPLEHEART
SAPELE
SPANISH CEDAR
TEAK
WALNUT
WESTERN RED CEDAR
ZEBRAWOOD